The Breitling Watch Source Forums https://breitlingsource.com/phpBB2/ |
|
Wakmann Details https://breitlingsource.com/phpBB2/viewtopic.php?f=5&t=66648 |
Page 1 of 1 |
Author: | heinkel_guy [ Sun Jan 12, 2020 11:42 am ] |
Post subject: | Wakmann Details |
Hi readers. I took possession of my father-in-law's Wakmann watches. I am trying to determine the dates of each. Any ideas? He passed away a few years ago, and I didn't know these existed. Otherwise I would have asked him for the details. Thanks! Mike McWilliams |
Author: | WatchFred [ Sun Jan 12, 2020 12:39 pm ] |
Post subject: | Re: Wakmann Details |
no way to precisely date these, 1950s & 1960s |
Author: | heinkel_guy [ Sun Jan 12, 2020 1:30 pm ] |
Post subject: | Re: Wakmann Details |
Thanks for you reply! Do you know if the center watch is older or newer than the outer two? The center one has different button styles and the crystal is a bit "taller". The outer two appear to be identical with the exception of the watch color and the font used for the numbers. Mike |
Author: | WatchFred [ Sun Jan 12, 2020 2:10 pm ] |
Post subject: | Re: Wakmann Details |
watches keft and right were made in France, Venus-based; the watch in the center is one of the high end models by Gigandet and houses a Valjoux R72, all from a similar period, late 50s and early/mid 60s |
Author: | heinkel_guy [ Mon Jan 13, 2020 5:43 am ] |
Post subject: | Re: Wakmann Details |
Fred, thank you once again for your details. Where was the Gigandet model manufactured? I am hoping to find receipts for these watches - my father-in-law saved everything! I am hopeful, but I doubt I will find the paperwork. He was in Europe until about 1960 and then New York City until 1960 or so. I think either location is possible. After leaving NYC, he moved to the middle of the USA and I doubt he would have bought the watches there. I had the Gigandet cleaned and repaired. It would not run, but now it is fantastic. The other two run well, but need the crystals polished. I will keep all three forever. But, I do not want to spend too much on small repairs. Do you have an estimated value for these? I'd rather not clean and/or repair them for $400 if the overall value is $450. Mike |
Author: | WatchFred [ Mon Jan 13, 2020 5:59 am ] |
Post subject: | Re: Wakmann Details |
Gigandet were manufactured in Tramelan, Switzerland. Wakmann were only distributed in the US, so most probably bought there in the 1960s. would value the "Gigandet" at roughly $/€ 2-2.2k, the other two around $/€ 6-800 |
Author: | heinkel_guy [ Mon Jan 13, 2020 4:16 pm ] |
Post subject: | Re: Wakmann Details |
Fred, Thank you again! Mike |
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |