I was looking into buying some clear adhesive watch protection pads to keep the crystal from getting scratched when polishing. Does any one know what size I would need for a navitimer world. They
have sizes ranging from 10mm up to 45mm.
| The Breitling Watch Source Forums https://breitlingsource.com/phpBB2/ |
|
| Navitimer world crystal, what size https://breitlingsource.com/phpBB2/viewtopic.php?f=12&t=45241 |
Page 1 of 1 |
| Author: | FULL_LING2012 [ Thu Jan 24, 2013 2:27 pm ] |
| Post subject: | Navitimer world crystal, what size |
I was looking into buying some clear adhesive watch protection pads to keep the crystal from getting scratched when polishing. Does any one know what size I would need for a navitimer world. They have sizes ranging from 10mm up to 45mm.
|
|
| Author: | Roffensian [ Thu Jan 24, 2013 4:13 pm ] |
| Post subject: | Re: Navitimer world crystal, what size |
Most people just use paper and masking tape, but if you need to know just measure it. |
|
| Author: | FULL_LING2012 [ Thu Jan 24, 2013 7:09 pm ] |
| Post subject: | Re: Navitimer world crystal, what size |
Trying to get masking tape to cover the crystal exactly while still leaving the bezel exposed is too much work. Polishing by hand in the first place is a lot of work, why make it harder. Check these out, just throw one on and go to town with your cape cod. http://www.ofrei.com/page227.html |
|
| Author: | Roffensian [ Fri Jan 25, 2013 5:08 am ] |
| Post subject: | Re: Navitimer world crystal, what size |
I guess too much work is relative 
|
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|