The Breitling Watch Source Forums https://breitlingsource.com/phpBB2/ |
|
Suitable replacement pusher for 806 - advice sought https://breitlingsource.com/phpBB2/viewtopic.php?f=11&t=64329 |
Page 1 of 1 |
Author: | buddman [ Thu Apr 19, 2018 11:55 am ] |
Post subject: | Suitable replacement pusher for 806 - advice sought |
I ordered what I thought were suitable replacement 2.50mm pushers from Cousins (part number C9117) which I though were correct, but the pusher rods are about 1mm too short to engage the chrono mechanism. Reading through the forum, I see I'm not the first to encounter this, but couldn't see any non custom solutions noted. Does anoyone know if there is a correct part to order, or altertive item at another vendor? Dave |
Author: | saabreit [ Sun Apr 22, 2018 10:28 pm ] |
Post subject: | Re: Suitable replacement pusher for 806 - advice sought |
Most simple solution is to machine small brass shouldered tubes that come on the screw heads and go close to chronograph on-off and reset pallets . It can be done easily with a watchmaker lathe. |
Page 1 of 1 | All times are UTC - 8 hours |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |