| The Breitling Watch Source Forums https://breitlingsource.com/phpBB2/ |
|
| 806 Movement Redial? https://breitlingsource.com/phpBB2/viewtopic.php?f=31&t=64597 |
Page 1 of 1 |
| Author: | Fixumkeepum82 [ Tue Jul 17, 2018 5:21 am ] |
| Post subject: | 806 Movement Redial? |
Attachment: 20180717_091746.jpg Attachment: 20180717_091714.jpg Some info would be helpful, does this look original or a redial or fake? |
|
| Author: | buddman [ Tue Jul 17, 2018 5:54 am ] |
| Post subject: | Re: 806 Movement Redial? |
it looks like an original disaster. |
|
| Author: | Fixumkeepum82 [ Tue Jul 17, 2018 6:08 am ] |
| Post subject: | Re: 806 Movement Redial? |
Is there any way I can get this serviced? Or is it just good for parts |
|
| Author: | buddman [ Tue Jul 17, 2018 7:04 am ] |
| Post subject: | Re: 806 Movement Redial? |
i think the dial is too far gone. Some watchmakers seem to raise rusty movements from the dead, but i would pass personally unless it was super cheap, i'd get it for parts. |
|
| Author: | saabreit [ Tue Jul 17, 2018 8:35 am ] |
| Post subject: | Re: 806 Movement Redial? |
Rust does not look so extended, it looks like superficial , not a real issue . |
|
| Author: | buddman [ Tue Jul 17, 2018 8:49 am ] |
| Post subject: | Re: 806 Movement Redial? |
saabreit wrote: Rust does not look so extended, it looks like superficial , not a real issue . You've still go a risk. I remember Craig did one for me where the rust was near the stem (as it normally would be). The stem had snapped off right at the far end and I had to source a whole new movement plate (possibly from Fred IIRC). Wasnt straightforward. Anyway, as I said, rust doesn't stop some watchmakers. |
|
| Author: | vintage [ Wed Jul 18, 2018 4:44 am ] |
| Post subject: | Re: 806 Movement Redial? |
Agree, the rust doesn't appear to be much of a problem on this one but the dial is another matter. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|