The Breitling Watch Source Forums

Breitling Watch Information Forums, Navitimer, Chronomat
It is currently Thu Apr 18, 2024 9:43 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 15 posts ] 
Author Message
 Post subject: microadjustment
PostPosted: Fri Nov 26, 2010 1:53 am 
Offline
Breitling Enthusiast
Breitling Enthusiast
User avatar

Joined: Mon Oct 11, 2010 2:01 pm
Posts: 94
Likes: 0 post
Liked in: 1 post
Hey everyone, I haven't got my bergeon tool yet but would like to adjust the clasp microadjustment on my pilot bracelet to a tighter position.

Is there anything else I might have lying around I could use to do this?

and,

what is the best way to adjust it? Do I press one side in and then move the pin behind the clasp so it is depressed. Then do the saem on the other side? And finally pull the microadjustment bar into the new position where it should click in?

Any advice is greatly appreciated!



timeczar likes this post.
Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 2:38 am 
Offline
Contributing Moderator
Contributing Moderator
User avatar

Joined: Tue Jul 24, 2007 11:39 am
Posts: 12837
Likes: 148 posts
Liked in: 519 posts
Location: UK
tubs wrote:
Hey everyone, I haven't got my bergeon tool yet but would like to adjust the clasp microadjustment on my pilot bracelet to a tighter position.

Is there anything else I might have lying around I could use to do this?

and,

what is the best way to adjust it? Do I press one side in and then move the pin behind the clasp so it is depressed. Then do the saem on the other side? And finally pull the microadjustment bar into the new position where it should click in?

Any advice is greatly appreciated!

A cocktail stick will do the job, but then so will anything with a reasonably fine point. A ballpoint pen is probably too thick and a needle would be too thin, but anything in between should be fine.

Best way to adjust it is the depress one side and actually move it into the next hole. There is enough play between the bracelet and clasp to do that. Then do the same on the other side. If you have both ends of the spring bar not seated in a hole at the same time you risk the spring bar pinging out completely..... which is slightly more of a pain to put back.

_________________
Driver8

Site Moderator
Image


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 8:45 am 
Offline
Contributing Member
Contributing Member

Joined: Thu Sep 27, 2007 11:48 pm
Posts: 3806
Likes: 11 posts
Liked in: 19 posts
Location: Sweden
Another reason to go with a toothpick or a cocktail stick is that it's wooden or plastic and that won't scratch the metal. Any metal object, like a needle or similar, might scratch the watch if you're unlucky.

_________________
Collection: http://s540.photobucket.com/albums/gg32 ... mview=grid


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 8:51 am 
Offline
Contributing Member
Contributing Member
User avatar

Joined: Wed Feb 25, 2009 10:19 am
Posts: 6003
Likes: 0 post
Liked in: 0 post
Location: Arkansas, USA
And for goodness sake if you're using a Bergeon 6767-F tool make sure you are using the correct end.

That forked end just absolutely will not work no matter how long or hard you try.

And to think, I actually do surgery on people. :roll:


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 9:14 am 
Offline
All Roads lead to Breitling
All Roads lead to Breitling
User avatar

Joined: Sat Jan 09, 2010 6:01 pm
Posts: 8010
Likes: 3 posts
Liked in: 33 posts
I prefer a wood chisel. :)

Actually in a pinch I've always used a simple push pin. So far, no untoward marks.

_________________
SHARKMAN


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 9:15 am 
Offline
All Roads lead to Breitling
All Roads lead to Breitling
User avatar

Joined: Sat Jan 09, 2010 6:01 pm
Posts: 8010
Likes: 3 posts
Liked in: 33 posts
br549 wrote:
And for goodness sake if you're using a Bergeon 6767-F tool make sure you are using the correct end.

That forked end just absolutely will not work no matter how long or hard you try.

And to think, I actually do surgery on people. :roll:



I pray I don't get very ill visiting Arkansas.

_________________
SHARKMAN


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 3:46 pm 
Offline
Contributing Member
Contributing Member
User avatar

Joined: Wed Feb 25, 2009 10:19 am
Posts: 6003
Likes: 0 post
Liked in: 0 post
Location: Arkansas, USA
sharkman wrote:
br549 wrote:
And for goodness sake if you're using a Bergeon 6767-F tool make sure you are using the correct end.

That forked end just absolutely will not work no matter how long or hard you try.

And to think, I actually do surgery on people. :roll:



I pray I don't get very ill visiting Arkansas.


Oh Sharkman not to worry. Stuff like that is rare and usually only happens when I'm sober. It's amazing how a few shots of JD will completely squelch that pesky tremor and make that scalpel cut as smooth as silk.


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Fri Nov 26, 2010 3:50 pm 
Offline
All Roads lead to Breitling
All Roads lead to Breitling
User avatar

Joined: Sat Jan 09, 2010 6:01 pm
Posts: 8010
Likes: 3 posts
Liked in: 33 posts
br549 wrote:
sharkman wrote:
br549 wrote:
And for goodness sake if you're using a Bergeon 6767-F tool make sure you are using the correct end.

That forked end just absolutely will not work no matter how long or hard you try.

And to think, I actually do surgery on people. :roll:



I pray I don't get very ill visiting Arkansas.


Oh Sharkman not to worry. Stuff like that is rare and usually only happens when I'm sober. It's amazing how a few shots of JD will completely squelch that pesky tremor and make that scalpel cut as smooth as silk.



Well then, I feel much better.

_________________
SHARKMAN


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sat Nov 27, 2010 6:01 am 
Offline
Breitling Enthusiast
Breitling Enthusiast
User avatar

Joined: Mon Oct 11, 2010 2:01 pm
Posts: 94
Likes: 0 post
Liked in: 1 post
hahaha cheers for the responses....I seem to be stuck between two micro adjustment points. When I'm warm my wrist is 7" and the looser is best and when I'm cold my wrist measures 1/4" less and the next tighter point is best!!! I'll have to bring the bergeon around with me when it arrives!! :D


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sat Nov 27, 2010 7:24 am 
Offline
All Roads lead to Breitling
All Roads lead to Breitling
User avatar

Joined: Sat Jan 09, 2010 6:01 pm
Posts: 8010
Likes: 3 posts
Liked in: 33 posts
tubs wrote:
hahaha cheers for the responses....I seem to be stuck between two micro adjustment points. When I'm warm my wrist is 7" and the looser is best and when I'm cold my wrist measures 1/4" less and the next tighter point is best!!! I'll have to bring the bergeon around with me when it arrives!! :D


That's why I carry a spare tip from the Bergeon in my wallet - the pin end comes in handy if I need to take it in or move it out one spot. Especially handy living in a hot climate when going from 110 degrees outside to 70 degrees inside. Because I am THAT anal.

_________________
SHARKMAN


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sat Nov 27, 2010 7:45 am 
Offline
Breitling Fanatic
Breitling Fanatic
User avatar

Joined: Mon Mar 22, 2010 9:10 am
Posts: 480
Likes: 0 post
Liked in: 0 post
Location: lugano, switzerland
aleister wrote:
Another reason to go with a toothpick or a cocktail stick is that it's wooden or plastic and that won't scratch the metal. Any metal object, like a needle or similar, might scratch the watch if you're unlucky.


exactly, no needs to have a bergeon, come on

_________________
Breitling Antares B10047
Breitling Chronomat B13050
Breitling Chronomat A13050.1 - pilot bracelet
Breitling Chronomat Blackbird A13050.1 - serie spéciale
Breitling Avenger Seawolf E17370
Breitling Chronomat EVO A13356 - pilot bracelet


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sat Nov 27, 2010 8:18 am 
Offline
Breitling Maniac
Breitling Maniac
User avatar

Joined: Sun Jun 06, 2010 6:49 pm
Posts: 1340
Likes: 0 post
Liked in: 0 post
Location: Texas
sharkman wrote:
tubs wrote:
hahaha cheers for the responses....I seem to be stuck between two micro adjustment points. When I'm warm my wrist is 7" and the looser is best and when I'm cold my wrist measures 1/4" less and the next tighter point is best!!! I'll have to bring the bergeon around with me when it arrives!! :D


That's why I carry a spare tip from the Bergeon in my wallet - the pin end comes in handy if I need to take it in or move it out one spot. Especially handy living in a hot climate when going from 110 degrees outside to 70 degrees inside. Because I am THAT anal.


And I thought I was bad by having an LED in my car fior when I want to charge my lume. This just takes the cake


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sat Nov 27, 2010 8:37 am 
Offline
All Roads lead to Breitling
All Roads lead to Breitling
User avatar

Joined: Sat Jan 09, 2010 6:01 pm
Posts: 8010
Likes: 3 posts
Liked in: 33 posts
thomasenlow1 wrote:
sharkman wrote:
tubs wrote:
hahaha cheers for the responses....I seem to be stuck between two micro adjustment points. When I'm warm my wrist is 7" and the looser is best and when I'm cold my wrist measures 1/4" less and the next tighter point is best!!! I'll have to bring the bergeon around with me when it arrives!! :D


That's why I carry a spare tip from the Bergeon in my wallet - the pin end comes in handy if I need to take it in or move it out one spot. Especially handy living in a hot climate when going from 110 degrees outside to 70 degrees inside. Because I am THAT anal.


And I thought I was bad by having an LED in my car fior when I want to charge my lume. This just takes the cake



Hey it doesn't even set off a metal detector. And the LED flashlight in the car? Well who doesn't. What if I get stranded in the middel of nowhere in a blizzard? How else will I know what time it is? :lol:

_________________
SHARKMAN


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sun Nov 28, 2010 2:58 am 
Offline
Contributing Member
Contributing Member

Joined: Thu Sep 27, 2007 11:48 pm
Posts: 3806
Likes: 11 posts
Liked in: 19 posts
Location: Sweden
tubs wrote:
hahaha cheers for the responses....I seem to be stuck between two micro adjustment points. When I'm warm my wrist is 7" and the looser is best and when I'm cold my wrist measures 1/4" less and the next tighter point is best!!! I'll have to bring the bergeon around with me when it arrives!! :D


Maybe you could have one of those instant pocket warmers in your pocket and just make sure that the wrist is warm at all times... ;)

_________________
Collection: http://s540.photobucket.com/albums/gg32 ... mview=grid


Top
 Profile  
Reply with quote  
 Post subject: Re: microadjustment
PostPosted: Sun Dec 16, 2018 4:32 pm 
Offline
Breitling Newbie
Breitling Newbie

Joined: Sun Dec 16, 2018 4:27 pm
Posts: 1
Likes: 0 post
Liked in: 0 post
I found that my wrist got larger in the colder weather. Strange. Anyway, an X-Acto knife did a great job on pushing in the microadjusters.


Top
 Profile  
Reply with quote  

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 15 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 29 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
 




Powered by phpBB® Forum Software © phpBB Group