Hello every one! How to remove the pins from the bracelet? I know this question might sound dumb, but I’ve tried to push out the pins without damaging the inner thread without luck

By the way for the guys been looking for a good source for Bergeon tools in U.S., try the following store http://www.ottofrei.com . I just bought a 1.6mm Bergeon screw driver from them, great service and good price.

Well technically http://www.ottofrei.com is the jewellery arm, http://www.ofrei.com is the watchmaking supplies.

If you have successfully removed the screw then I'm assuming that it's stray loctite that's stopping you from being able to remove the pins.

You are removing both screws on the link aren't you? The pin is a part of a complete link. In order to remove the pin the entire link has to be taken out which means both screws in the link need to be removed.

Thank you guys! I successfully resized the links, and swaped the Diver strap out for the bracelet! Man, installing the bracelet was not easy. Scratched up the inner horns during the process. I had to drag the end links to line up the pin and the hole on the horn. Does any body have tips or tricks that will help me remove/install the bracelet without sratch up the inner horns? I have a custom leather strap from Rob Montana on the way, that I want to install. Thanks!