The Breitling Watch Source Forums
https://breitlingsource.com/phpBB2/

Suitable replacement pusher for 806 - advice sought
https://breitlingsource.com/phpBB2/viewtopic.php?f=11&t=64329
Page 1 of 1

Author:  buddman [ Thu Apr 19, 2018 11:55 am ]
Post subject:  Suitable replacement pusher for 806 - advice sought

I ordered what I thought were suitable replacement 2.50mm pushers from Cousins (part number C9117) which I though were correct, but the pusher rods are about 1mm too short to engage the chrono mechanism. Reading through the forum, I see I'm not the first to encounter this, but couldn't see any non custom solutions noted.

Does anoyone know if there is a correct part to order, or altertive item at another vendor?


Dave

Author:  saabreit [ Sun Apr 22, 2018 10:28 pm ]
Post subject:  Re: Suitable replacement pusher for 806 - advice sought

Most simple solution is to machine small brass shouldered tubes that come on the screw heads and go close to chronograph on-off and reset pallets . It can be done easily with a watchmaker lathe.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/