The Breitling Watch Source Forums

Breitling Watch Information Forums, Navitimer, Chronomat
 
It is currently Thu Nov 15, 2018 2:10 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Apr 19, 2018 11:55 am 
Offline
Breitling Connoisseur
Breitling Connoisseur

Joined: Fri Mar 28, 2014 1:06 pm
Posts: 729
Likes: 109 posts
Liked in: 130 posts
Location: London
I ordered what I thought were suitable replacement 2.50mm pushers from Cousins (part number C9117) which I though were correct, but the pusher rods are about 1mm too short to engage the chrono mechanism. Reading through the forum, I see I'm not the first to encounter this, but couldn't see any non custom solutions noted.

Does anoyone know if there is a correct part to order, or altertive item at another vendor?


Dave


Top
 Profile  
Reply with quote  
PostPosted: Sun Apr 22, 2018 10:28 pm 
Offline
Breitling Connoisseur
Breitling Connoisseur

Joined: Sun Jan 22, 2012 10:20 am
Posts: 752
Likes: 3 posts
Liked in: 128 posts
Most simple solution is to machine small brass shouldered tubes that come on the screw heads and go close to chronograph on-off and reset pallets . It can be done easily with a watchmaker lathe.



buddman likes this post.
Top
 Profile  
Reply with quote  

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
 

All Watch Sites 
Powered by phpBB® Forum Software © phpBB Group