The Breitling Watch Source Forums

Hi All,
I need help with my Top Time 2000 (gold plated / black dial & silver subdials) project that I've been working on for about 6 months.
The only part missing now is the crown.
Does anyone know what size i should be looking for (diameter / width / tap size)?
I measured my wifey's Top Time 2003 crown (posted here few months back), that's around 5.86mm diam / ~3mm wide, but I'm not sure if the 2000 would be the same size, and (without disassembling) I couldn't measure the tap size, either.
If someone happens to have one lying around, that'd be even better - PM me with an offer.
Thanks in advance folks,
Bless you all

size is correct, bit below 6mm.
not easy to find in GP

sorry, overlooked the stem question, tap 6 1.2mm

Thanks a lot Fred;

Do you think this would fit (even though it's slightly larger in diameter)?:
http://www.ebay.co.uk/itm/231857184419? ... EBIDX%3AIT

Or, would it be a bad idea to plate a ss one?

Thanks,
Lev

nope, would not look right on a 2000

if done properly, plating an ss will work.

Awesome, thanks a lot Fred... again!