The Breitling Watch Source Forums

.? Please don't laugh ,as I was checking out my electronic warranty that shows the watch model ,serial #, placed purchased and date on the back .when I grabbed it to remove it from the leather case ,I noticed I must have pressed dwn to hard with fingers ,so like a LED screen it shows a light print on the screen .,,normal or if others have done this will it go away back to normal .?? thanks to all

Really no one has ever had this issue b4??

Totally normal, however, you have to take it back to the original AD that is listed on card (plus COSC certificate) to reset it/remove the fingerprint.

Thx got it

I didn't take mine to the original AD or take the COSC. They reset it in seconds at Andrew Michaels in the UK. Then I smudged it again when I got home! Steve.

_________________
Quite a few Breitlings, most of them starting with the letter C.

I just bought a brand new Super Avenger II from tourneau, and 2 weeks later the card was a mess. Huge spots all over the card inside and you could not read any of the info. Went back and they replaced it no problem. Most of the spots came out of nowhere as the card was in the box, but once a few showed up, if I even slightly pressed it, it created a spot. Hope it does not happen to me again.

They are a form of e-ink screen, when they are put on to the reader it 'refreshes' the screen similar to a kindle and restores the display, takes seconds. They are a bit delicate for sure though, almost all of the ones that have come through our stores have varying levels of 'bleed' to them.